Wine & Beverage Center FAQs : Installation


Haier - Wine Cellar Installation Location and Clearance

Your wine cellar is designed for freestanding installation only. It should not be recessed or built-in.Installation considerations:Do not install your wine cellar in any location not properly insulated or heated, e.g. garage, attic, etc. Your wine cellar was not designed to operate in temperature se...

Haier - Starting a New Beverage Center

Before plugging the unit in:If it was transported on its side, the unit should be stood upright for an equal amount of time as it was on its side before plugging it in.If it was on its side for more than a day, leave standing for 24 hours before running.If it was laying on its side just briefly to s...

Haier - Beverage Center Leveling

Your beverage center has two leveling legs which are located in the front bottom corners of your unit. After properly placing your beverage center in its final position, you can level it.Leveling legs can be adjusted by turning them counter clockwise to raise your beverage center or by turning them ...

Haier - Beverage Center Clearances

To ensure your beverage center works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation and electrical connections.Check the Owner's Manual for the recommended clearances for your specific model.

Haier - Wine Cellar Clearances

To ensure your wine cellar works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation and electrical connections.Check the Owner's Manual for the recommended clearances for your specific model.

Haier - Wine Cellar Leveling

The wine cellar has four leveling legs, one leveling leg in each corner. After placing your wine cellar in the desired location, make sure that it is level from front to back and side to side.The leveling legs can be adjusted by turning them clockwise to raise or counterclockwise to lower.The wine c...

Haier - Wine Cellar Door Alignment

To adjust the door alignment, especially after initial installation:Make sure the wine cellar is unplugged.Remove the top hinge cover by using a flathead screwdriver. Place the head under the front edge of the cap and gently lift.Gently move wires aside.Loosen the top hinge screws using a Phillips h...

Haier - Beverage Center Installation Location and Clearance

Your beverage center is designed for freestanding installation only. It should not be recessed or built-in.Installation considerations:Provide proper air clearances. To ensure your refrigerator works at the maximum efficiency it was designed for, you should install it in a location where there is pr...

Haier - Beverage Center Reversing the Door Swing

The door hinges are factory installed on the right-hand side. If you want the doors to open from the opposite direction, you can reverse the door swing.Reversing the door:Before you begin, unplug the refrigerator, or disconnect power.The door is heavy and fragile and the door front is glass. To avoi...

Haier - Wine Cellar Use of Extension Cord

Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must...

Search Support

Search our knowledge base for help with installation, operation, troubleshooting, and more.

Product Manuals

Enter your appliance's model number to download manuals for your product.

fa fa-3x fa-calendar-check-o hover-texts
Schedule Service

Service & repair for your kitchen, laundry, or air product.

fa fa-3x fa-wrench hover-texts
Parts & Accessories

Order accessories and repair parts from our parts store.

fa fa-3x fa-phone hover-texts
Contact Us

Still have questions? We've got your back. Chat, email, or give us a call.